Hi !
Ref : Olinuxino LIME2 4G with new 3.4.112 kernel
When installing to NAND, on the console I see a lot of :
PHY_PageRead : too much ecc err,bank 0 block 276,page 4
PHY_PageRead : too much ecc err,bank 0 block 276,page 18
and so on ...
Sometimes the installation succeeded, sometimes not, but the system is often instable, and finally, fully unusable.
I tried all the precompiled images, then I compiled myself, but the same problem ...
Until now, I used 3.4.106 without problems
Thanks for support !
Greetings ,
