hi all,
i need add extra ethernet card for my cubietruck A20
I have lindy based on Manufacturer: ASIX Elec. Corp
I have read this topic but i did not understand all.
in my cubie when attach the card in dmesg have :
[ 722.103004] usb 4-1: new high-speed USB device number 6 using sw-ehci [ 782.958675] ehci_irq: port change detect
lsusb
Bus 004 Device 007: ID 0b95:1790 ASIX Electronics Corp.
in another pc with when attach the card
[21892.375550] usb 3-1.2: New USB device found, idVendor=0b95, idProduct=1790 [21892.375557] usb 3-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [21892.375560] usb 3-1.2: Product: AX88179 [21892.375563] usb 3-1.2: Manufacturer: ASIX Elec. Corp. [21892.375566] usb 3-1.2: SerialNumber: 000050B616192E [21892.718677] ax88179_178a 3-1.2:1.0 eth1: register 'ax88179_178a' at usb-0000:00:1a.0-1.2, ASIX AX88179 USB 3.0 Gigabit Ethernet, 00:50:b6:16:19:2e [21893.082286] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready [21895.537107] ax88179_178a 3-1.2:1.0 eth1: ax88179 - Link status is: 1 [21895.549066] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
is possible enable module in kernel 3.4.104-sunxi?
how can i do?
regards